Jump to content
Forums Gone... but not forgotten!
Pontiac of the Month

2 Firebirdz's 1976 Trans Am

2024 November
of the Month

  • Rev up your passion for Pontiacs and join our vibrant community of enthusiasts!

    Whether you're a die-hard fan of classic muscle cars or you've got a soft spot for sleek modern models, you've found your home here at Forever Pontiac. Our community is dedicated to celebrating everything Pontiac, from the iconic GTO to the legendary Firebird and everything in between.

    Unlock access to expert advice, stunning photo galleries, engaging discussions, exclusive events, and more!

    Start your Pontiac journey with us today!

    Sign up now! 🏁

Drivers side window won't roll down


Go to solution Solved by awingpilot,

Recommended Posts

I need help with getting my drivers side window to roll down on my 2005 GTO. Has anybody else had this problem? Does anybody have any ideas?   It rolls up but not down . changed the motor and checked it before we installed it and it went up and down just fine. put it in and it only went up. Any help would be great


 


 


                                               Thanks Jim


Link to comment
Share on other sites

Tired of these Ads? Register Today!

I need help with getting my drivers side window to roll down on my 2005 GTO. Has anybody else had this problem? Does anybody have any ideas?   It rolls up but not down . changed the motor and checked it before we installed it and it went up and down just fine. put it in and it only went up. Any help would be great

 

 

                                               Thanks Jim

Sounds like you checked it, OUT of the car before installing?  Could be your up/down switch????

Link to comment
Share on other sites

we checkrd the window switch first its sending voltage down to the motor. Changed the body control module(big mistake didn't know it needed to be re-programed) Shut down the whole car. We did check the motor out side of the car. we checked the relay for the windows it was good too.I don't know where to go from here.


Link to comment
Share on other sites

  • 4 weeks later...

If the switch is sending voltage to the motor then I don't know why Its not working. Did you check for voltage when you pressed both up AND down? I'm just throwing stuff at the wall here.


Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Tired of these Ads? Purchase Enhanced Membership today to remove them!
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.