Jump to content
Forums Gone... but not forgotten!
Pontiac of the Month

FBIRD69's 1969 Firebird

2024 March
of the Month

  • Rev up your passion for Pontiacs and join our vibrant community of enthusiasts!

    Whether you're a die-hard fan of classic muscle cars or you've got a soft spot for sleek modern models, you've found your home here at Forever Pontiac. Our community is dedicated to celebrating everything Pontiac, from the iconic GTO to the legendary Firebird and everything in between.

    Unlock access to expert advice, stunning photo galleries, engaging discussions, exclusive events, and more!

    Start your Pontiac journey with us today!

    Sign up now! 🏁

Question about a pontiac 400 engine


Recommended Posts

Tired of these Ads? Register Today!

  • Replies 32
  • Created
  • Last Reply

Top Posters In This Topic

Is the positive crankcase ventilation important for the pontiac 400 motor ?

It's important for all motors.  You will always have a certain amount of BLOW-BY past your rings and into the crankcase. This is not only exhaust, but unburn't fuel as well.  (imagine what that's doing to your oil) The PCV is vacume back into the intake.  Much like an EGR valve your reusing the hot gas and recycling.  This helps with keeping the fuel and the hot exhaust gases (inside the crankcase) from destroying your oil, helps lower overall engine temp as well. Most older engines will also have breathers in the valve covers to help with excess.  But thats spraying all over your valve covers unless you have the factory set up with a tube and filter going back to your air cleaner housing.

Link to comment
Share on other sites

I'll second what justa said.The unburned gas fumes etc will ruin a motor in no time.Changing oil is cheap as well,once its hooked back up though after a few miles alot of the crap will naturally get burned out of the oil.(get a new mechanic as well)


Link to comment
Share on other sites

Follow your diagrahm.  You should have a plugged off vacume port somewhere already.  Measure your new length of hose to that.  Unless you have recently changed your oil, I agree with Indy... that would be cheap insurance.  Hope that relieves some of the pressure off those seals.


Link to comment
Share on other sites

  • 2 weeks later...

Recheck your firing order.  Pontiac goes in a "counterclockwise" pattern.  It will seem to idle fine until you give it gas, if you have the firing order wrong or in the wrong direction around the cap.   18436572  Line up your timing marks, pull the cap. Usually #1 is on the pass side, see where your rotor is pointing. (The only way to make 100% sure your not 180 off, is to pull the valve cover. Turn the engine over by hand, follow your intake runner for #1 to the intake valve. After the intake opens, your on the compression stroke. Now line your timing marks. )  Where the rotor is pointing is your #1 follow the firing order counterclockwise around the cap. 


Link to comment
Share on other sites

I switched my Sunbird over and regret every minute of it.  If the car gets wet....will cost me 115.00 for a new module. I have to carry spares. VERY EXPENSIVE.  When it's running, it's cool.  Kept my GTO points set up.  Still running the original set I put in 5 years ago with NO prob's.


Link to comment
Share on other sites

I have no idea what setup you went with. I'm using the Mallory Light trigger. I just bolted in using the existing screw holes. If yours was the same, you should be able to put the points, condenser and correct rotor, right back in.  Are you using the stock cap?


Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



Tired of these Ads? Purchase Enhanced Membership today to remove them!
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.