Jump to content
Forums Gone... but not forgotten!
Pontiac of the Month

Shakercars's 1972 Trans Am

2019 August
of the Month

  • Welcome!

    Welcome to Forever Pontiac, full of great ideas for Pontiac performance, maintenance, or for peer-to-peer assistance from Professional and DIY mechanics. Also, compete in our Pontiac monthly competitions. Please register if you'd like to take part.

Recommended Posts

So I have a GT and I'm in the process of swapping the BCM off of a GTP to get the HUD working, I hear if I disconnect the BCM I will trip safe mode... What do I need to do to swap it correctly? 

Share this post


Link to post
Share on other sites

Tired of these Ads? Register Today!

33 minutes ago, Georgia Prixs said:

So I have a GT and I'm in the process of swapping the BCM off of a GTP to get the HUD working, I hear if I disconnect the BCM I will trip safe mode... What do I need to do to swap it correctly? 

I have never needed to do anything with my BCM, but there is a company that can most likely help answer your question. https://newrockies.com/ 

There are a lot of things I have deleted from my GP & some have been security aspects, but not all and none have been removed off the BCM

As a side note, the GPs did not have to be a GTP to have HUD.

Share this post


Link to post
Share on other sites

I wish it was this easy I have a 2001-03 and they removed the pigtails for the HUD and HUD switch off the harness sadly 

Share this post


Link to post
Share on other sites
Posted (edited)
17 minutes ago, Georgia Prixs said:

I wish it was this easy I have a 2001-03 and they removed the pigtails for the HUD and HUD switch off the harness sadly 

There is place up here called Morad Parts. https://moradpartscompany.com/ they have always been good to deal with. I see the have a couple BCMs, but what they may have that they don’t show online are wiring harnesses. You might call and talk to them. They have always been quite knowledgeable & helpful. Ed is the owner, if you can talk to him. 

Edited by Last Indian

Share this post


Link to post
Share on other sites
On 7/24/2019 at 3:38 PM, Georgia Prixs said:

I wish it was this easy I have a 2001-03 and they removed the pigtails for the HUD and HUD switch off the harness sadly 

IF YOU DO NOT HAVE ACCESS TO THE TECH TERMINAL, A 30 MINUTE RELEARN PROCEDURE MUST BE PERFORMED BY FOLLOWING THESE STEPS:

PLACE A JUMP PACK ON THE VEHICLE. DO NOT LET THE BATTERY DROP BELOW 11.5 VOLTS.

TRY AND START THE VEHICLE.

RETURN THE KEY TO THE RUN POSITION.

WAIT 10 MINUTES. (10)

TURN THE KEY FROM RUN TO OFF.

RETURN THE KEY BACK TO THE RUN POSITION.

WAIT 10 MINUTES. (20)

TURN THE KEY FROM RUN TO OFF.

RETURN THE KEY BACK TO THE RUN POSITION.

WAIT 10 MINUTES. (30)

AFTER THE FINAL 10 MINUTES, RETURN THE KEY TO THE OFF POSITION. THE NEXT CYCLE OF THE KEY WILL NOW RE-LEARN THE PASSLOCK DATA INTO THE REPLACEMENT MODULE.PERSONALIZATION SETTINGS IN THE DRIVER INFORMATION CENTER MAY NEED TO BE RESET. PLEASE CONSULT YOUR OWNER'S MANUAL FOR VEHICLE PERSONALIZATION.

Share this post


Link to post
Share on other sites

For sure? I'll try it... 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Tired of these Ads? Purchase Enhanced Membership today to remove them!
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.