Discussion
Sign in to follow this
Followers
0
Discuss what is going on in Great Lakes.
80 topics in this forum
-
- 3 replies
- 64 views
-
- 8 replies
- 190 views
-
- 6 replies
- 322 views
-
- 0 replies
- 121 views
-
- 0 replies
- 77 views
-
- 5 replies
- 434 views
-
- 5 replies
- 455 views
-
- 40 replies
- 1,632 views
-
- 10 replies
- 580 views
-
- 20 replies
- 863 views
-
- 0 replies
- 353 views
-
- 0 replies
- 177 views
-
- 31 replies
- 940 views
-
- 22 replies
- 841 views
-
- 8 replies
- 525 views
-
- 13 replies
- 620 views
-
- 30 replies
- 1,252 views
-
- 9 replies
- 516 views
-
- 1 reply
- 1,281 views
-
- 20 replies
- 810 views
-
- 86 replies
- 3,364 views
-
- 80 replies
- 2,701 views
-
- 2 replies
- 592 views
-
- 16 replies
- 1,619 views
-
- 0 replies
- 437 views
Sign in to follow this
Followers
0
-
Posts
-
By TWO LANE BLACK TOP · Posted
Were the cylinder heads redone.??..Were Valves ground and sealing good.?? Are all the valve stems the same height.?? With new matching valve springs locks and retainers and not coil binding??...Hydraulic or solid lifters.??..Also what method did you use to set the valve lash..?? -
By cruisercrazy · Posted
rebuilt motor but now when you try to rev up on it it wants to pop thru the carb has everything new in it cam lifters push rods timing chain and gears idles fine just cant rev it up any suggestions would be appreciated I've moved timing every which way to see if it would help but doesn't seem to help any -
EEEEEW AAAAAH Nice! Happy N safe holiday buddy. Did get the veneer back from staining. Need time to install on the dash. -
I am finally getting around to the body work, found a lot more rust than I anticipated covered by some of the worst body work I have ever seen. Try a thin piece of galvanized sheet metal pop riveted on over a 6 inch hole in the bottom of the front fender covered by about a quarter inch of bondo. I have found a source for most of the plastic trim clips, some are for other GM products which I have successfully modified to work. The ones I am having trouble with are the metal clips for the rocker moldings. The clips on the right side are in pretty bad shape and the ones on the left side are gone completely. The genius that did the gruesome body work just put a long hanger at the top molding line that the molding hooks on to and screwed the ends down to put pressure on the hanger to keep it from popping off. I have been periodically doing google searches for molding clips and I have found most, either from aftermarket manufacturers primarily AMK or on ebay. Thus far I have not been able to locate the rocker clips. If anyone knows of a source I would appreciate a heads up. -
Post script to anyone that may be looking for the final answer. That answer is to buy a Robbins top. It goes on and fits right. The staple lines are in the right place and when installed according to instruction it works right.
-
-
Images
-
0By Targetfast7, -
0By Targetfast7, -
0By Targetfast7, -
0By Targetfast7, -
0By Targetfast7,
-
